- Have you ever bought an RC product and get mad because you had to spend another $200 to make your engine a "Performer Engine"? Well not any more when you purchase an RC gas engine from JEL motors. JEL motors are custom built RC gas engines made to your specific needs for use in off road, road course, dirt and asphault oval, or even for just entertainment uses. In short JEL creates a High Powered RC gas engine for the Weekend Warrior that are built to Last.
- A Cooler motor: Normal out-of-the-box RC engines run at temps of 230-240 degrees. JEL built RC engines run at 190-210 degrees, and that's with both the head and block having matching temps!
- Fuel Efficient: After a single standard track race with a 2 minute warm up, and a 4 minute race, a normal out-of-the-box RC engine uses about 7/8 of a fuel tank. JEL built RC engines uses on average a half a tank, just about having enough fuel to run two races on the same tank! (Especially nice for those people who forget to refuel!).
- More Power:Cooler motor = More Power, any gearhead knows this theory. You get a nitro RC engine running 30% Blue Thunder to run a 6 min run. You finish first and come off the track with head/crank temp 179 degrees. Cool running engine creates more torque. Torque = Power.
- Greater RPM range: When an RC motors run cooler means you must lean out the top in needle to generate a higher head temp. In ball park (after breakin) JEL motors RC engines top end needle is adjusted at 3/4 to 1 1/4 turns out. With that in mind, these RC motors allow higher RPM's do to a greater air to fuel ratio. All motors are limited to inlet air by the carb venturi diameter. By getting the motor cooler, it allows less fuel to cool motor, which in turn lets more air in for greator top RPM. The fun part comes in where you figure out the gearing for your RC car. If you have ever run moified electric these motors are as fun as a D-5 flatwire!!!
Unlike manufacturers, all of JEL motors RC engines are broken in with one quart of 10% nitrous fuel. In addition, JEL motors builds your RC engine to match the gearing with the transmission being used. And finally upon delivery, an exhaust pipe is then specified to use to create optimum performance for the JEL motors built RC engine when it is delivered. On average, the normal life expectancy of an out-of-the-box RC engine from a manufacturer that needs a break in period, lasts about 2 gallons. RC Engines from JEL motors on average last 4 gallons with High Performance throughout!
With a JEL built custom RC engine, JEL motors clients will immediately experience four things:
Overall, JEL clients recieve an RC gas engine with the best possible performance for any specific track or entertainment purpose!
